Every supplier says yes. The ones worth working with are the ones who can tell you where the line is. Here is ours, in plain terms.
Raw fibre, carbonisation and large-tow production are not ours. We make parts from fibre, we do not make the fibre. Saying so costs us a few enquiries and saves both sides a wasted audit.
If your part needs an approval we do not hold, we will not make it and pretend the paperwork will follow. We will tell you who does hold it.
A complex part at low volume is not economical to mould. If the numbers do not work, we will say so — and often recommend aluminium, a hybrid, or CNC from plate.
Tight hole positions on a thin, flat panel are a forming limit, not a machining limit. We will tell you which dimension has to move and by how much, rather than promising it and failing the batch. Any tolerance we do quote comes with its measurement method and the instrument used on the first article report.
Standard epoxy systems are not rated for continuous high-temperature exposure. We will tell you when the operating temperature rules the material out.
Carbon fibre is conductive. If your application depends on insulation or a specific dielectric property, that has to be reviewed before the design is fixed.
Structural adhesives, splicing compounds and strengthening systems with their design and site works belong to another chain. We can supply fabric; we do not sell the system around it.
We will not compress a cure cycle or skip a first article to hit a date. We will give you the honest date and let you decide.
These four come up in almost every first call. The answers are short on purpose.
No. Raw fibre and carbonisation are upstream of us. We make the parts — plate, tube, profiled sections and moulded components. We buy fibre by grade, verify every incoming lot against its certificate, and keep the lot number on the batch record.
No. We buy T700-grade carbon fibre by grade and verify it per lot. We do not market ourselves under anyone else’s name, and we do not use a brand name to imply a relationship that does not exist.
No, and we do not take airworthiness parts. What we do is execute to your drawing tolerance, issue a first article report with measured values, and give you material traceability. Industrial and consumer structures are where we belong.
We can supply the fabric. We do not do the works. Strengthening needs design qualification, construction qualification and a full set of test reports — that is a different chain with different liability, and we do not mix it into ours.
The real cost of the wrong supplier is not the price on the quotation. It is the batch that arrives and cannot be used, the tool that was cut for a process that was never right, the audit that discovers none of it was recorded. Declining work that should not be done is part of doing the work that should be done properly.
The DFM review is free and happens whether or not you place an order with us.
These photographs show the material stage before we ever see it. We buy by grade, verify every lot against its certificate, and take it from fibre into parts — plate, tube, moulded and machined. We do not own the equipment in this section, and we do not claim to.
Carbon fibre tow on cones
UPSTREAM
Prepreg roll
UPSTREAM
Weaving line for carbon fabric
UPSTREAM
Unidirectional prepreg
UPSTREAM
Precursor tow on a creel
UPSTREAM
Prepreg coating line
UPSTREAMThe distinction is worth making: a factory that owns the forming lines and says so is easier to verify than one that quietly implies it also spins the fibre.